⚠ Attention, this model is being replaced Read this page: ⚠ Smoke detector Zigbee Heimann HS1SA-E? HS1SA-E Plus? HS1SA-EF?

 

🔍 I check the received model

🛒 Where to buy this equipment?

Here is the link to the page dedicated to HS1SA-E. I referenced the sellers and prices.

📦 Product Description

The detector is compact, comes with a bracket to glue or screw to the ceiling. A set of screws is provided, the installation is simple.

🔋 I spot the yellow tab that has to isolate the battery

I remove the base (just unscrew a few degrees), then I pull the tab to power the detector.

🔗 I integrate this detector with Zigbee2MQTT

I put Zigbee2MQTT in pairing mode when I remove the tab, but nothing happens (this is not automatic on this model). So I find the small hole on the side, I slide a trombone into it to press for a few seconds until the LED flashes green. The pairing starts immediately and, in a few seconds, the module is integrated! The detector is well recognized in HS1SA, and the image displayed in Zigbee2MQTT perfectly matches the actual module. All important data are well documented: Please note: there are no specific configuration parameters.

🖊 I rename the detector

✅ I test the operation on Zigbee2MQTT

When the detector is at rest, here are the values received: I press the test button on the detector: On Zigbee2MQTT, the states Smoke and Testing Let's go to True. In case of real fire, only Smoke should move on to True.

🏠 I find the detector in Home Assistant

I can find my equipment there right away. Perfect integration: all information (battery, status, alert) is displayed without additional configuration. Within seconds, I have a fully functional detector.

📑 For archive: instructions for use

• Version M419-9Ever1.2 in PDF